Rubber adhesives are special gluey substances used for the
purpose of metal to metal pasting or rubber to metal pasting. Since its
usage is a bit different from other adhesives, it comprises of special
additives and chemicals to increase the pasting intensity as well as be
durable enough to withstand extremely hot or cold temperatures. Metals like
aluminum, steel, copper etc. use rubber adhesives as a bonding agent for
pasting purposes. Here are the application instructions regarding
rubber adhesive
Inspect the Metal Structure
Check the joint design of the metals to be pasted so that you have a fair
idea of the component and your requirements regarding the same. Prior
inspection of the structure can also decrease the chances of potential
failure of the planned task. Besides, one can also decide on to a suitable
adhesive for the same.
Rubber Adhesives
Swipe Clean the Metal Surface
Make sure that the metal surface is swiped cleaned to remove all kinds of
dirt, dust and grease. In fact, the surface needs to be cleaned chemically
by using either acetone or isopropyl alcohol.
Opening Rubber Adhesives Tubes
Open the adhesive tubes by pricking it with a sharp needle or a similar
object. In case there is some kind of doubt regarding the adhesive and
metal, try it first on smaller part as a sample. Once you are sure of the
metal and adhesive bonding, go ahead with the entire job.
Application Procedure
Use small amounts of adhesive while pasting the metal. The most apt way of
applying the rubber adhesive is to first use it sparingly and then carefully
spread it on the metal surface in a thin layer. For best results let both
the surfaces stick together firmly by pressurizing it from both the sides.
Do not try to part the surfaces from one another until the surfaces are
firmly pasted.
Polyethylene(CSM)/
Hypalon
Want Competitive Quotes from Verified Suppliers?